Status Commands
These commands set or query the related data from both Questionable Status
Register and Operation Status Register which mainly include:
[:]status:operation:condition?
[:]status:operation:enable
[:]status:operation[:event]?
[:]status:preset
[:]status:questionable:condition?
[:]status:questionable:enable
[:]status:questionable[:event]?
The principle of Status Register is shown in Figure 2-1, which contains Questionable
Status Register, Operation Status Register, Event Status Register and Status Byte
Register as well as Output Buffer and Error Queue. The status commands set or query
the Questionable Status Register and Operation Status Register in Status Register.
About the detailed operation of IEEE488 commands to Event Status Register and
Status Byte Register as well as Output Queue and Error Queue, please refer to
IEEE488 commands in Chapter2.
To Next Page
Loading...
