Trigger Commands
The commands are used to set trigger parameters, such as trigger times, trigger
delayed time and so on. It is suggested that the command ―SENSe:<function>:
RANGe:AUTO OFF‖ should be used to disable autorange function, the commands
―SENSe:<function>:RANGe, CONFigure‖ or ―MEASure?‖ be used to set range by
manual.
Which mainly include:
TRIGger:COUNt
TRIGger:DELay
TRIGger:DELay:AUTO
TRIGger:SLOPe
TRIGger:SOURce
To Next Page
Loading...
