Rigol DM3058 - Page 209

RIGOL
Programming Guide for DM3058
5-93
Explanations:
SYSTem:COMMunicate:LAN:DDNS□{ON|OFF}: Turn dynamic DNS(DDNS) on or
off.
SYSTem:COMMunicate:LAN:DDNS?: Query the switch state of dynamic DNS.
If the setting of DDNS is changed, the new configuration will be effective when
power is on.
Return Format:
The query returns the switch state of DDNS.
6. SYSTem:COMMunicate:LAN:DHCP
Command Format:
SYSTem:COMMunicate:LAN:DHCP□{ON|OFF}
SYSTem:COMMunicate:LAN:DHCP?
Function:
The command sets or queries the enable state of DHCP (Dynamic Host
Configuration Protocol).
Explanations:
SYSTem:COMMunicate:LAN:DHCP□{ON|OFF}: Enable or disable DHCP.
SYSTem:COMMunicate:LAN:DHCP?: Query the enable state of DHCP.
If DHCP is ON, the multimeter will try to obtain an IP address from DHCP. If a
DHCP is found, it will assign a dynamic IP address, Subnet Mask, and Default
Gateway to the instrument.
When DHCP is OFF, the multimeter will use the static IP address, Subnet Mask,
and Default Gateway during power-on.
Return Format:
The query returns the enable state of DHCP.
7. SYSTem:COMMunicate:LAN:DNS
Command Format:
SYSTem:COMMunicate:LAN:DNS□"<address>"
SYSTem:COMMunicate:LAN:DNS?□[{CURRent|STATic}]