1. :system:beeper
Command Format:
:system:beeper
Function:
The command tests the beeper.
Explanations:
The command enables the beeper beep only one time when testing. Before
sending this command, please do open the beeper.
2. :system:beeper:state
Command Format:
:system:beeper:state?
:system:beeper:state□{ON|OFF}
Function:
The command queries and sets the switch state of beeper .
Explanations:
:system:beeper:state?: Query whether the beeper is on.
:system:beeper:state□{ON|OFF}: Set
the switch state of beeper. The parameter
―ON‖ means turn on the beeper, ―OFF‖ means turn off. If the beeper was off by
using ―OFF‖, ―:system:beeper‖ is invalid when next test.
Return Format:
The query returns the beeper state. ―ON‖ returns 1, or else returns 0.
Example:
To turn on the beeper:
:system:beeper:state□ON
3. :system:configure:poweron
Command Format:
To Next Page
Loading...
