15
Remote Control
The instrument can be remotely controlled by the following three methods:
• User-defined Programming
You can program and control the instrument by using the SCPI (Standard
Commands for Programmable Instruments) commands. For details about the
SCPI commands and programming, please refer to the
Programming Guide
of
the series.
• PC Software
You can use the PC software to send commands to control the instrument
remotely. Ultra Sigma of RIGOL is recommended. You can log in to RIGOL official
website (
http://www.rigol.com
) to download the software.
Operation Procedures:
- Set up communication between the instrument and PC.
- Run Ultra Sigma and search for the instrument resources.
- Open the remote command control panel to send commands.
• Web Control
This instrument supports Web Control. When connected to the network, the
Web Control will display the real-time interface displayed on the instrument
screen. Through the Web Control method, you can migrant the device control to
the control terminals (e.g. PC, Mobile, iPad, and other smart terminals) to realize
remote control of the instrument. When you first log in to the Web Control, the
user name is "admin" and password is "rigol".
This instrument can be connected to the PC via the USB or LAN interface to set up
communication and realize remote control through the PC. The remote control is
realized via SCPI commands.
This chapter will illustrate how to use the RIGOL Ultra Sigma software to remotely
control the instrument via various interfaces.
TIP
Before setting up communication, please turn off the instrument to avoid causing damage to
the communication interfaces.
15.1 Remote Control via USB
1. Connect the device
Remote Control
DP900 User Guide
80
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
To Next Page
Loading...
Need help?
General
