Name: Rigol DS1054Z
Brand: Rigol
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Chapter 1 Disassemble and Assemble RIGOL

MSO1000Z/DS1000Z Service Guide 1-5

To Disassemble the Rear Metal Cover

Figure 1-3 To Disassemble the Rear Metal Cover

Part Explanation:

① 11 screws (torx countersunk head screw M3*6) fixing the front metal plate and

rear metal cover (the positions of some of the screws are not marked out in the

figure above and please disassemble them according to their actual positions).

Disassemble Steps:

1. Remove the 3 (for MSO1000Z-S/DS1000Z-S) nuts and washers at the BNC ports

on the rear metal cover using the BNC socket. Note that for

MSO1000Z/DS1000Z, there are only one BNC nut and washer.

2. Remove the 11 screws (①) fixing the front metal plate and rear metal cover

using the screwdriver (T10).

3. Remove the power cord and fan cable connected to the main board and take off

the rear metal cover gently.

Rear Metal Cover

①

BNC Washer

BNC Nut

Other manuals for Rigol DS1054Z

Questions and Answers:

Need help?

Do you have a question about the Rigol DS1054Z and is the answer not in the manual?

General