Rigol MSO1104Z Programming Guide

RIGOL Chapter 2 Command System
2-4 MSO1000Z/DS1000Z Programming Guide
:ACQuire Commands
The :ACQuire commands are used to set and query the memory depth, acquisition mode and the number of
averages as well as query the current sample rate of the oscilloscope.
Command List
[1]
:
 :ACQuire:AVERages
 :ACQuire:MDEPth
 :ACQuire:TYPE
 :ACQuire:SRATe?
Note
[1]
: In the "Command List" in this manual, the parameters in the setting commands and the query commands are
not included and you can refer to the complete introductions of the commands in the text according to the keywords.
:ACQuire:AVERages
Syntax
:ACQuire:AVERages <count>
:ACQuire:AVERages?
Description
Set or query the number of averages under the average acquisition mode.
Parameter
Name
Type
Range
Default
<count>
Integer
2
n
(n is an integer from 1 to 10)
2
Explanation
 You can sent the :ACQuire:TYPE command to set the acquisition mode.
 In the average acquisition mode, greater number of averages can lower the noise
and increase the vertical resolution, but will also slow the response of the displayed
waveform to the waveform changes.
Return
Format
The query returns an integer between 2 and 1024.
Example
:ACQuire:AVERages 128 /*Set the number of averages to 128*/
:ACQuire:AVERages? /*The query returns 128*/

Rigol MSO1104Z Specifications

General

Brand	Rigol
Model	MSO1104Z
Category	Test Equipment
Language	English