RIGOL
22 MSO8000 Quick Guide
Remote Control
MSO8000 series digital oscilloscope can be connected to the PC via the USB,
LAN, or GPIB interface to set up communication and realize remote control
through the PC. The remote control can be realized by using SCPI (Standard
Commands for Programmable Instruments) commands. MSO8000 series digital
oscilloscope supports three ways of remote control: user-defined programming,
PC software (e.g. RIGOL Ultra Sigma), and Web Control.
More Product Information
1. Obtain the device information
Press Utility System About to obtain the information of the
instrument, such as the manufacturer, model, serial number, hardware
version number, etc. You can also open the "Help" menu, and then press
About to obtain the device information.
2. View the option information and the option installation
The instrument is installed with the trial versions of the options before
leaving factory. When you power on the instrument for the first time after
leaving factory, the trial time is about 2,160 minutes. Open the "Help"
menu, and then press Option list to view the options currently installed
on the oscilloscope and their information. Press Option setup to install
the option. For detailed setting methods, refer to descriptions in
MSO8000
User's Guide
.
For more information about this instrument, refer to the relevant manuals by
logging in to the official website of RIGOL (www.rigol.com) to download them.
MSO8000 User's Guide
: introduces the functions of the instrument and the
operation methods, remote control methods, possible failures and solutions in
using the instrument, the technical specifications, and order information.
MSO8000 Programming Guide
: provides detailed descriptions of SCPI
commands and programming examples of the instrument.
MSO8000 Datasheet
: provides the main features and technical specifications of
the instrument.
To Next Page
Loading...
Need help?
General
