What to do if my Riland Multipro 200SP Welding System has no welding output?
If the Riland Welding System's meter shows a value, the fan is working, but there's no welding output, first ensure all machine sockets are well connected. Check for open circuits or poor connections at the output terminal. Inspect the torch control cable for severance or switch damage. Finally, consider the possibility of damage to the control circuit.
How to troubleshoot a Riland Multipro 200SP with no power?
If the meter shows nothing, the fan isn't rotating, and there's no welding output from your Riland Welding System, first, ensure the power switch is turned on. Second, check that power flows through the input cable. Third, inspect the silicon bridge for any damage. Lastly, consider the possibility of a failure in the additional power source located on the control board.
What to do if Riland Multipro 200SP Welding System has abnormal indicator lights?
If your Riland Welding System shows a value on the meter, the fan is working normally, but the indicator lights are abnormal, it could be due to the over current protection device. In this case, turn off the power switch and restart the machine after the abnormal indicator light turns off. It might also be due to the overheating protection device. If so, wait for about 2-3 minutes until the machine cools down without turning off the power switch. Finally, it may indicate a multifunction of the inverter circuit.
General| Brand | Riland |
|---|---|
| Model | Multipro 200SP |
| Category | Welding System |
| Language | English |
To Next Page
