6
Avoiding Electromagnetic Interference
Users should ensure that the welding power supply and other equipment in the environment do
not produce electromagnetic interference, otherwise corresponding shielding and protection
measures should be taken.
According to the manufacturer's suggestion, the power source should be connected to the main
power supply line.
The length of welded cables should be shortened as far as possible to make them close to each
other and to the ground.
Safety of all metal assemblies assembled by welding and the assemblies connected with them
should be confirmed.
The yellow-green grounding wire in the power line must be grounded, and the workpiece must
be well connected with the ground clamp.
Users should be responsible for the interference caused by welding.
Noise Produced during Welding can Easily Cause Hearing Loss
In order to avoid the harm of noise to you and others, please wear the prescribed protective
equipment.
Cautions for Hoisting
The power source with strap or handle is prohibited from using strap or handle for lifting.
When lifting power source with lifting forklift truck, in order to prevent dumping, please fork-fit
and fix it from side.
When lifting power source with crane, the cable should be tied to the suspension ring, and the
angle between the cable and the vertical direction should not exceed 15 degrees.
When the power source with cylinder and wire feeder is hoisted, the two equipments should be
To Next Page
Loading...
