ring Base Station User Manual

1716
Once you’ve installed your sensors, it’s good to
give them a descriptive name. In an emergency,
the name you choose may be sent to emergency
responders so they know the location where the
alarm signal was activated.
• Over time doors and windows can warp
causing a misalignment of the sensors, which
can activate the alarm.
• Make sure that every door and window where
you have a Ring Contact Sensor installed is
closed before you arm your system.
Ring Contact Sensor
Ring Contact Sensors can be installed on any
door or a window. They need to be perfectly
aligned and no more than 1/4” apart when the
door or window is closed. It doesn’t matter what
direction you install them or whether the sensor
or magnet goes on the trim.
To install the Contact Sensor:
1. Remove the brackets from the back of the
sensor and magnet.
2. Mount the brackets using the included tape
or screws.
3. Place the sensor and magnet onto their
brackets. They should snap into place.

ring Base Station Specifications

General

Brand	ring
Model	Base Station
Category	Security System
Language	English