Remove the plastic cover and
rubber pad from the base.
You’ll put the cover back on once
you’ve mounted your
Stick Up Cam.
Flip the base to the rear.
The base of the stand is hinged. Before wall-mounting, flip
the base down and behind your Stick Up Cam.
Push the rubber pad
back into the base.
The rubber pad should sit
between your wall and the
base of your Stick Up Cam.
How to install Stick Up Cam
on a wall:
Drive the screws.
Hold the round part of the base against your wall, rubber-
side down. Use the integrated level to ensure it’s straight.
Finally, mount it with the included screws.
Then, head to page 14 for the final steps.
1110
02_Stick_Up_Cam_Elite_MANUAL_FR-CA_EN.indd 10-11 9/26/19 12:42 PM
To Next Page
Loading...
