IMPORTANT POINTS
Unpack heater:
Check for damage. If heater is damaged, contact your supplier for advice. Before
installing the heater, check it is labelled for the correct gas type. Refer to local
gas authority for confirmation of gas type if you are in doubt.
Included in Carton:
Customers Operating Information/ Guarantee
IMPORTANT
1.
2.
3.
4.
5.
6.
7.
8.
The appliance must be installed to the requirements of the local gas authority.
For information on gas rate, see data plate on the appliance.
When installing this appliance, ensure that the room is correctly ventilated.
Check AG 601 or the Local Authority for information on ventilation
requirements.
DO NOT install in bedroom or bathroom.
This appliance must not be installed in close proximity to flammable
materials, e.g. curtains, and must be 50mrn clear of side walls.
This appliance is not designed to be built in.
If you move house, check the gas type in the area where you are moving to.
The Local Authority will be able to advise on local regulations.
This heater discharges a large volume of warm air at low level to provide
even heat distribution. If the air in the room contains cooking vapour or
cigarette smoke, and the heater is used on a carpet, the surface of the carpet
may become discoloured.
In addition, some nylon carpets contain dyes which may be affected by the
warm air flow.
Some soft vinyl surfaces are also subject to discolouration by warm air.
To prevent discolouration of carpets etc., a mat should be placed under the
appliance, extending about 750 mm in front of it.
.
.
a
.
.
.
.
Diagram
1 shows clearances required
around this unit whilst it is in operation.
-?-
To Next Page
Loading...
