26 Fan Convector Manual
1. Confirm that the heater is properly installed. See Installaon secon.
2. Make sure the gas valve on the propane gas bole or gas supply line is ON and that gas pressure is available.
3. Make a careful visual inspecon of all electrical connecon and wiring.
4. If trouble persists, refer to the following trouble shoong chart and corresponding remedy.
Troubleshoong:
Problem
Cause
No On indicator
Burner does not ignite
Filter warning lamp glows
Combuson stops during operaon
Takes too long to warm the room
Remedy
Not Plugged In
Plug in
Power Failure
Manually operate (push ON/OFF
Buon) aer power is restored.
(Inial Installaon)
Air in gas pipe
Purge air (Installer)
Room too large Check with retailer
Dust on the air filters Clean air filters (WEEKLY)
Louvre obstructed Clean obstrucon
Air filter blocked Clean filter (WEEKLY)
On/Off Timer is set Cancel On/Off Timer
Child Proof Lock set Cancel Child Proof Lock
Gas turned off at meter Turn gas on (SERVICER)
To Next Page
Loading...
Need help?
General