14 Fan Convector Manual
ConsumerOperaonGuidelinesfortheSafeOperaonofyourFanConveconHeater
FOR YOUR SAFETY READ BEFORE OPERATING
A. This appliance does not have a pilot. It is equipped
with an ignion device that automacally lights the
burner. Donottrytolighttheburnerbyhand.
B. BEFORE OPERATING smell all around the appliance
area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will sele
on the floor.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electric switch; do not use any
phone in your building.
Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instrucons.
If you cannot reach your gas supplier, call the fire
department
C. Use only your hand to push the in or turn the gas
control knob. Never use tools, If the knob will not
push in or turn by hand, do not try to repair it; call
a qualified service technician. Force or aempted
repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a licensed professional to
inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
WARNING
If you do not follow these instrucons exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
TO TURN OFF GAS TO APPLIANCE
1. Turn off all electric power to the appliance using
the ON/OFF buon.
2. Set the thermostat to the lowest seng.
3. Turn the manual valve clockwise to the full
OFF posion.
OPERATING INSTRUCTIONS
1. STOP! Read the safety informaon above.
2. Set the thermostat to the lowest seng.
3. Turn off all electric power to the appliance using
the ON/OFF buon on the control panel.
4. This appliance is equipped with an ignion device
that automacally lights the burner. Do not try to
light the burner by hand.
5. Locate the manual gas valve on the back side of
the heater. Turn the manual valve clockwise to
the full OFF posion.
6. Wait five (5) minutes to clear out any gas. Then
smell for gas, including near the floor. If you smell
gas, STOP! Follow “B” in the safety informaon
above. If you don’t smell gas, go to the next step.
7. Turn the manual gas valve counterclockwise
to the full ON posion.
8. Turn on all electric power to the appliance using
the ON/OFF buon.
9. Set the thermostat to desired seng.
10. Burner is lit when operaon lamp glows red.
11. If operaon lamp is flashing red,
burner has not been lit and an error
code will display.
12. If the appliance will not operate, follow the
instrucons “To turn off gas to appliance” and call
your licensed service technician or gas supplier.
To Next Page
Loading...
Need help?
General