Fan Convector Manual 27
DiagnoscCodes
This heater has the ability to check its own operaon connuously. Ifafaultoccurs,anErrorMessagewillflash
onthedigitaldisplayofthecontrolpanel.This assists with diagnosing the fault, and may enable you to
overcome a problem without a service call. Please quote the code displayed when inquiring about service.
If you see other codes displayed, contact Rinnai or your nearest service agent and arrange for a service call.
NOTE
In some cases, you may be able to clear the Error Message simply by turning the heater OFF, then ON again. If
the Error Message sll remains or returns on the next operaon, contact Rinnai or your nearest service agent
and arrange for a service call.
FC510
FC824
CODE DISPLAYED DEFINITION REMEDY
Tilt Switch Acvated
Missed Ignion
Flame Failure
Overheat
Room Overheat
Power Cut
Inspector gas line connecon, aer seng heater
upright. Turn heater ON
Check gas is turned ON,
Service call if repeated
Venlate the room.
Service call if repeated.
Clean filter.
Service call if repeated.
Service call.
Turn Heater OFF, then ON again