To Next PageTo Next PageWhat to do if Rinnai Water Heater starts then shuts down immediately?
If your Rinnai Water Heater starts and then immediately shuts down, verify that the power is still on. Also, check that the gas valve at the unit and the gas meter are fully open. Ensure that your hot water tap is fully open as well.
What to do if Flame Failure or Low gas flow in Rinnai INFINITY 32?
If you experience flame failure or low gas flow in your Rinnai Water Heater, first check that the gas is turned on at both the water heater and the gas meter. Then, check that nothing is obstructing the flue outlet. Finally, ensure you turn on the gas supply to the water heater.
What to do if Rinnai Water Heater starts then the water goes cold?
If your Rinnai Water Heater starts but the water then goes cold, check that the power is still on. Open your hot water tap further, or try another tap. Note that your unit requires a minimum flow of 3L/min to operate.
How to fix Rinnai INFINITY 32 Water Heater no ignition/no gas supply?
If your Rinnai Water Heater won't ignite due to a potential lack of gas supply, first, verify that the gas is turned on both at the water heater itself, and at the gas meter or cylinder.
What to do if Rinnai INFINITY 32 has flame failure / low gas flow?
If you're experiencing flame failure or low gas flow with your Rinnai Water Heater, start by checking that the gas is turned on at both the water heater and the gas meter or cylinder. Also, ensure there are no obstructions blocking the flue outlet.
What to do if Rinnai INFINITY 32 does not start?
If your Rinnai Water Heater isn't starting, make sure the power is on at the unit and check that the isolation valves are open.
What to do if power interruption during bath fill with Rinnai Water Heater?
If you experience a power interruption during a bath fill and the water doesn't flow when the power is restored with your Rinnai Water Heater, turn off all hot water taps and press the ON/OFF button twice.
What to do if Rinnai Water Heater does not attempt to start?
If your Rinnai Water Heater does not attempt to start, check that the power is on at the unit and that the cold water valve at the unit is also on.
What to do if Rinnai INFINITY 32 Water Heater has Over Temperature Warning?
If your Rinnai Water Heater is showing an Over Temperature Warning, it is recommended to request a service call.
What to do if Outgoing Water Temperature Sensor is Faulty in Rinnai INFINITY 32?
If the Outgoing Water Temperature Sensor in your Rinnai Water Heater is faulty, it is recommended to request a service call.
General| Type | Tankless |
|---|---|
| Gas Type | Natural Gas or Propane |
| Installation | Indoor or Outdoor |
| Energy Factor | 0.82 |
| Maximum Flow Rate | 9.8 GPM |
| Minimum Flow Rate | 0.4 GPM |
| Activation Flow Rate | 0.4 GPM |
| Ignition Type | Electronic |
| Temperature Range | 98°F to 140°F |
| Maximum BTU Input | 199, 000 BTU |
| Minimum BTU Input | 15, 000 BTU/hr |
| Venting | Direct Vent |
| Vent Material | PVC, CPVC |
| Electrical Requirements | 120V, 60Hz |
| Warranty | 12-year heat exchanger, 5-year parts, 1-year labor |
