01/18 34
5.13 Ending duties
At the end of the duties you proceed as follows:
1. Stop the engine.
2. Tidy up the HP reel.
aClose the HP valve.
b Wind up the HP hose.
c Lock the HP hose in the hose holder.
d Lock the HP reel (position “O”).
e Lock the hose guide.
3. Tidy up the supply hose.
a Close all water taps.
b Close the supply tap.
c Uncouple the supply hose.
d Wind the supply hose.
e Couple the end of the supply hose to the frame.
f Lock the supply reel.
4. Tidy up all accessories.
5. Tidy up the remote control.
6. Drain the water that is still left in the water tank by means of the draw-
off tap.
7. Couple the trailer to your car.
The trailer can now be moved.
5.14 Using the device during periods of frost
Your high-pressure device may freeze up during a period of frost. A number of
safety precautions must be taken.
Additional preparations before departure:
1. Drain the water tank and the water filter.
2. Close the drain valve and mount the filter again.
3. Put approximate 30 litre of antifreeze into the anti freeze tank.
4. Open the anti freeze valve.
5. Open the high-pressure valve.
6. Start the machine and let it idle.
Note: it is not necessary to attach either a nozzle or a gun to the high-
pressure control.
7. Push button (Start spraying) on the control box.
8. Let the high-pressure pump remove all the water, which is still in the
high-pressure hose.
9. Close the high-pressure valve when anti freeze comes out of the hose
(wait for the blue colour of the antifreeze).
10. Leave the engine running for some time: to allow all pipes to fill up with
antifreeze.
To Next Page
Loading...