Setting and Unsetting
Page 22
3. During the exit delay time period:
the keypad beeps
the
icon flashes
the icon lights
indicating that the interior zones are being omitted.
4. When the exit delay time period has expired, the
icon lights steadily.
Notes:
1. Press to cancel the Entry Delay time period for the current partial setting.
2. Press during the exit delay time period to silence the keypad beeps.
Partition Setting
A key LightSYS2 advantage is its ability to divide the system into up-to-four partitions. Each
partition can be managed as a separate security sub-system, that is, set and unset
individually, regardless of the condition of the others
Partitions can be set and unset one at a time, or all at once, and each partition can be set as
Partial Set or Full Set. Only users who have been defined to operate multiple partitions can
operate more than one partition and simultaneously set / unset all partitions.
To set specific partitions:
1. Verify that the system is ready to set.
2. For Full Set, enter your user code followed by
or hold the tag close to the
keypad's keys. For Partial Set, press
.
3. Select the number of the partition you want to set.
Notes:
If your user code is assigned to more than one partition, use the or keys to
select the required partition(s) and press . Select "0" to set all partitions assigned
to a code.
4. Press
/ Present Tag (For Full Set) or press (Partial Set) to set the selected
partition(s).
5. Repeat the above steps to set additional partitions
To Next Page
Loading...
