User Functions and Settings
Page 37
Omitting zones
When an intrusion zone is not secured, the keypad's Ready/ icon will not light, nor can
the system be readily set. Omitting a zone enables you to set a partition even if a zone
within that partition is open (not secured).
You may want to omit a zone when access is needed to one zone in an otherwise protected
area, or to cause the system to temporarily circumvent a zone containing damaged wiring
until repairs can be made.
Warning:
An omitted zone may reduce the system's security capability.
To view Not Ready zones:
Before performing the following procedure, identify the violated zone(s) as follows:
1. Enter your user code followed by
2. Scroll down with the
key to view all "not ready" zones. The LCD only displays
"not ready" zones that belong to the user code that was entered.
To change a zone's omit status:
1. Press and enter your code followed by .
2. Scroll to Activities and press
.
3. Select Omit and press
.
4. Select Zones and press
.
5. For omitting a zone only for the next system setting select One Time Only. If you
want to omit the zone permanently select Permanent Omit.
6. Scroll down the list of zones and using
to select the zones to be omitted.
7. To confirm press
.
Notes:
You can access the one-time omit option in a quick way by pressing [Code][
].
Zones defined for One Time Only omit are automatically un-omitted
when the system is set and then subsequently unset.
The icon turns off when setting in Full Set mode.
To Next Page
Loading...
