Risco LightSYS2 - Adding a New Proximity Tag

User Functions and Settings
Page 34
Adding a New Proximity Tag
You can add a new proximity tag for each user in the system, as required.
To add a new proximity tag:
1. Press
and enter your code followed by .
2. Using the arrow keys, scroll to the option Codes/Tags and press
.
3. Scroll to Define and press
.
4. Select the user to which you want to assign the proximity tag and press
. Each
proximity tag can be assigned to only one user.
Note:
A display of (****) indicates that a user has already been assigned to a specific
proximity tag.
5. Scroll to (Re)write Tag. Press
.
Within 10 seconds, approach the proximity tag at a distance of 4 cm. from the front of
the keypad bottom. The keypad automatically reads the proximity tag and saves it
into the system's memory.
Once the proximity tag has been successfully recorded, a long confirmation beep
sounds, and a confirmation message is displayed.
If the proximity tag is already stored in the system's memory, the following message
is displayed:
USER TAG ALREADY IN MEMORY
Notes:
 Once a proximity tag is recognized, it will be functional from all keypads.
 The programmed proximity tag has the same permissions that are defined
for the specified user code.
 If a user is defined as having the Cleaner security level, then the proximity
tag can operate only if a security code was previously defined for that user.