Risco LightSYS2 - Delete a Keyfob

User Functions and Settings
Page 42
Delete a keyfob
1. Follow steps 1-3 of the previous procedure (See Assign New Keyfob)
2. Using the arrow keys, scroll to the Delete Keyfob option and press .
3. Press the key to start the keyfob erase mode.
4. Press the keyfob key for 3 seconds.
5. Repeat above steps for additional keyfobs. When finished press
to exit Erase
mode
Delete All keyfobs
1. Follow steps 1-3 of the previous procedure (See Assign New Keyfob)
2. Using the arrow keys, scroll to the Delete All Keyfobs option and press .
3. Use the key to toggle to Y and press .
Change keyfob buttons that controls the outputs
By default, button 3 (small round key) of the keyfob controls output 1 and button 4 (egg
shape) controls output 2. This can be changed for all the keyfobs that are already assigned
to the wireless receiver.
1. Follow steps 1-3 of the previous procedure (See Assign New Keyfob)
2. Using the arrow keys, scroll to the PO Buttons option and press
.
3. Use the key to toggle to Y and press . This will replace button 3 to button 1
and button 4 to button 2.