Rish Eine+ - Power Factor Meter

3.1.3.2 PF End Value (PF-E)
3.1.3 Power Factor Meter
This screen allows the user to set the PF End value which will correspond to the
Input End value.
The End value can be set from -1 to +1 (quadrants 1 & 2).
Initially, ‘PF-E’ message is displayed on screen following which user can start editing
PF End value by pressing the “ ” key.
Instead on pressing the “ ” key will confirm the present value and advance to
PF Start value selection (section 3.1.3.3).
Capacitive
Inductive
Capacitive
Inductive
PHASOR DIAGRAM
Phasor
Diagram
3.1.3.1 Input Start Value (inP.S)
Refer section 3.1.2.1.
13