Rish Eine+ - Table of Contents

PROGRAMMABLE DC DPM
Installation & Operating Instructions
Section Contents
1.
Introduction
2.
Measurement Reading Screens
3.
4. Installation
Programming
3.1 Setup Screens
3.1.1 Meter Type Selection
3.1.2 Normal Meter
3.1.2.1 Input start value
3.1.2.2 Display end value
3.1.2.3 Display start value
3.1.2.4 Bent function selection
3.1.2.5 Input bent value
3.1.2.6 Display bent value
3.1.3 Power Factor Meter
3.1.3.1 Input start value
3.1.3.2 PF end value
3.1.3.3 PF start value
4.1 EMC Installation Requirements
4.2 Case Dimensions and Panel Cut-out
4.3 Wiring
4.4 Auxiliary Supply
4.5 Fusing
4.6 Earth / Ground Connections
5.
Connection Diagrams
Specifications
6.
DC Voltmeter : Eine Voltage
+
DC Ammeter : Eine Current
+
3.2 Other Display Indications
3