17
For 48 x 96mm-Mounting of Rish
Eine+ DC DPM 48 x 96 is featured with
easy “Clip- in” mounting. Push the meter
in panel slot (size 48.5 x 96 mm), it will
click fit into panel with the four integral
retention clips on two sides of meter.
The front of the enclosure conforms to
IP54. Additional protection to the panel
may be obtained by the use of an
optional panel gasket. The terminals at
the rear of the product should be
protected from liquids.
The Rish Eine+ DC DPM should be mounted in a reasonably stable ambient
temperature and where the operating temperature is within the range -10°C to 55°C
. Vibration should be kept to a minimum and the product should not be mounted
where it will be subjected to excessive direct sunlight.
Caution
1. In the interest of safety and functionality this product must be installed by a qualified
engineer, abiding by any local regulations.
2. Voltages dangerous to human life are present at some of the terminal connections of
this unit. Ensure that all supplies are de-energised before attempting any connection
disconnection.
3. These products do not have internal fuses therefore external fuses must be used to
ensure safety under fault conditions.
58.1mm
5mm
66.6mm
To Next Page
Loading...
Need help?
General
