Riso 7330 - Page 15

1-5
1
ComColor GD Series Troubleshooting Guide
Check the Stripper Unit.
The stripper unit is not installed properly.
Reinstall the stripper unit.
Installing the stripper unit
Message Action to Take
Stripper
unit
1 Lower the stripper lock knob (a) to
unlock the stripper unit.
2 Press the stripper release lever (b) and
remove the stripper unit.
3 Reinstall the stripper unit.
4 Lift the stripper lock knob to lock the
stripper unit.
When the stripper lock knob cannot be
locked, the stripper unit is not fully
inserted.
Make sure that the stripper unit is fully
inserted.
• Make sure that the stripper unit is
fully inserted.