11
Checks and Maintenance
Before performing fusions and before connecting to power outlet, check the
following:
NOMINAL TENSION AND FREQUENCY : see technical features (page 7)
OUTLETS AND EXTENTION CABLES: they must be suitable for the power absorbed by
machine ( see page 7, 10)
CABLES: isolation has to be intact, they have to be placed away from places
where vehicles transit and where they can be damaged .
MACHINE BODY: it has to be isolated and placed steadily.
Keep machine and cables clean and dry. Before cleaning operations
disconnect machine from power supply. Use a humid soft cloth with water and
alcohol (avoid any kind of solvent).
ELEKTRA is an electronic equipment therefore it has to be handled safely avoiding
impacts and sudden temperature changes.
To guarantee correct functioning for as long as possible, operators has to
perform frequent checks to the following components :
• Connectors and adapters
• Power cables and fusion cables
• Display
• Mechanical structure (frame, box).
In case of any anomaly machine has to be checked by manufacturer or by an
authorized service centre.
In any case machine has to be serviced every 2 years by manufacturer or by an
authorized service centre.
To Next Page
Loading...
