RKC INSTRUMENT CB700 User Manual

3. SETTING FOR COMMUNICATION
IMCB03-E3
12
!
Setting procedure
Example: When setting data construction to "1: 8 data bits, no parity bit and 2 stop bits."
1. Change the controller to communication setting mode, and then display the data construction
(See P. 5, 6).
2. Press the UP key to enter "1" in the lowest digit. As a result, data construction is set to "8 data
bits, no parity bit and 2 stop bits."
3. Press the SET key to change to the next communication parameter. As a result, the set data
construction is registered.
Data construction
SET
R/S
SV
PV
ALM2ALM1AT OUT2OUT1
SET
R/S
SV
PV
ALM2ALM1AT OUT2OUT1

RKC INSTRUMENT CB700 Specifications

General

Brand	RKC INSTRUMENT
Model	CB700
Category	Controller
Language	English