EAGLE 2 Operator’s Manual Alarms • 295
3. The LCD will show the following screen for a few seconds with
the “S” in the lower right corner indicating the unit is entering
Setup Mode.
4. The “S” will then disappear and the following screen will appear
for a few seconds.
5. If the unit prompts you for the password, enter it by using the AIR
▲ YES or RANGE ▼ SHIFT buttons to select each password
number and then pressing and releasing the POWER ENTER
RESET button to enter it and move on to the next number until all
of the numbers are entered. The main menu displays. It displays
six menu items at a time.
6. Use the AIR ▲ YES or RANGE ▼ SHIFT button to move the cursor to
the ALARM POINTS menu item.
7. Press and release POWER ENTER RESET. The Change Alarm Point
Settings Screen appears and all detection channels are displayed.
>SET DATE & TIME
SET DATE FORMAT
SET BATTERY TYPE
CONFIGURE CHANNELS
CONFIGURE GASES
CATALYTIC UNITS
CHANGE ALARM
POINT SETTINGS
> 1: CH4 2: OXY
3: H2S 4: CO
END
To Next Page
Loading...
Need help?
General
