19 • Display Mode Eagle Instruction Manual
Display Mode
The Eagle has four operating modes: normal operating mode, display
mode, setup mode, and calibration mode. With the Eagle in display
mode, you can:
• set user and station IDs
• display peak readings
• display elapsed time
• display TWA and STEL readings (toxic gases only)
• display battery voltage
• display date and time (data logging option only)
• clear the data log (data logging option only)
• display remaining log time (data logging option only)
To enter display mode, from the normal screen press the DISP/ADJ
button. To scroll from one screen to the next press the DISP/ADJ
button.
NOTE: Each screen displays for 20 seconds. If you do not press the
DISP/ADJ button to scroll to the next screen within 20
seconds, the Eagle automatically returns to the normal
operating screen.
User and Station ID Screen
This screen displays only if the user ID function is activated (see
“Turning the User ID Function On or Off” on page 35). Each ID
contains 10 characters. Uppercase letters, numbers, asterisks (*), and a
blank space are available characters.
Use this screen to identify user, location, or other information. If your
Eagle includes the data logging option, the User and Station ID
provides a way to identify the user and location of exposure. The User
and Station ID are saved to the data logger when you turn off the
Eagle, so you can update the IDs for each data logging session.
SE
RD
A
TI
OT
IN
D
U
S
I
*
*********
*
*********
To Next Page
Loading...
Need help?
General
