07
SECTION I
MANUAL FOR MECHANICAL PARTS
Contents:
1. Conditions for Riding This Electric Bicycles
2. Selection and Set-up
3. Safe Cycling and Safety Tips
4. Routine Maintenance Check and Lubrication
5. Assembly Instructions
1.Conditions for Riding this Electric Bicycles
This electric bicycle is designed for riding on a road or a paved surface where the tires do not
lose ground contact, and this electric bicycle must be under proper maintained according to
the instruction of this manual. The maximum weight of the rider and load is required to be less
than 200lb (or 90kg).
Warning: You are warned that you take the consequences such as personal injury, damage,
or losses if you breach the above conditions and in the meanwhile, the warranty will be void
automatically.
2. Selection and Set-up
2.1. Saddle and Handlebar Stem Adjustment
The seat can be easily moved either up or down. Adjust the seat to keep the rider's knee
maintaining a slight bend when his foot is in the lowest pedaling position(refer to fig. 3).
Handlebar stem is approximately on the same level as saddle or slightly lower. For some
more adjustment tips, please refer to fig. 4 as below:
Warning: If your seat post is not inserted up to the minimum
insertion mark, the seat post may break (refer to fig. 5)
Once the saddle is at the correct height, make sure the seat
post should be up to its minimum insertion mark.
Warning: handle stem minimum insertion mark on traditional
quill stems must not be visible above the top of headset.
If the stem is extended beyond the minimum insertion mark the
stem may break or weaken the fork steering tube.
To Next Page
Loading...
