• Replace entire seat belt if mounting hardware, buckle, belt, or retractor show signs of damage.
• Inspect seat belt and mounting hardware at least once a year. Look for signs of loose hardware or belt damage, such
as cuts, fraying, extreme or unusual wear, discolouration or abrasion. Replace only with replacement parts approved
by Roberine
• Layers of heavy clothing can interfere with proper positioning of the seat belt and can reduce the effectiveness of the
seat belt.
Roll-over Protection Structure
CAUTION! Keep the ROPS installed properly.
• Never operate the machine without the ROPS installed.
• Make sure all parts of the ROPS are installed correctly if the ROPS structure is loosened or removed for any reason.
All ROPS hardware should be tightened to the proper torque as per manufacturer’s recommendations.
• Any changes to the ROPS must be approved by the manufacturer. The protection provided by the ROPS will be
impaired if the ROPS is subjected to structural damage, is involved in an overturn incident, or is in any way altered by
welding, bending, drilling, or cutting.
• The seat is part of the ROPS safety zone. Replace only with a seat approved by Roberine.
• Never attempt to repair a damaged or altered ROPS. It must be replaced to maintain the manufacturer’s certification
of the structure.
2.5.2 Emergency stop
CAUTION! Always stay seated and hold the steering wheel when you need to make an emergency stop.
Leaving the seat or releasing the steering wheel may cause dangerous situations.
In case of emergencies:
1. Quickly remove your foot from the foot pedal.
The hydraulic brake will be activated.
2. If necessary, slowly pull the parking break until the machine slows down.
2.6 Instructions to the driver
The driver is responsible for working safely with the mower. When the driver does not follow the safety rules and
instructions, it can cause serious personal injury and damage to the machine.
The driver:
• has been trained and is qualified to operate the machine.
• is attentive to and avoids dangerous situations.
• always inspects the machine before use.
• tests the functioning of the machine.
• inspects the working environment.
• keeps bystanders at a safe distance.
• only uses the machine for which it is intended.
• wears the correct safety equipment and clothes.
• does not operate the machine when under the influence of medicines, alcohol or drugs.
• fully read and understood the safety and operating instructions.
• is familiar with local legislations and rules.
Safety 13
To Next Page
Loading...
