8.8 Fuel filter and fuel/water seperator
Inspect the fuel/water seperator after the first 50 hours of use. Replace the fuel filter every 500 hours or once a year.
Before you begin: Park the machine safely and let the engine cool down.
Replacing the fuel filter
OPMERKING Make sure the fuel level is low before you replace the fuel filter.
1. Open the bonnet.
2. Unscrew the fuel filter (1) and remove it.
3. Install new fuel filter.
4. Check the deposit container.
Checking the fuel/water seperator
1. Check if there is any water in the fuel/
water seperator (1).
The red ring inside will float on water.
2. If necessary, drain the water via the tap
(2) or clean the fuel/water seperator and
replace the filter:
a. unscrew the container from its top.
b. replace the filter.
c. screw the top back onto the
container.
3. Close the bonnet.
OPMERKING Tightening torque of the fuel/water seperator attachment strap: 15-20 Nm.
Maintenance 53
To Next Page
Loading...
