10 Recommissioning
When taking the machine out of storage:
1. Check the engine oil level (see Checking the engine oil level on page 49).
2. Check the electrolyte level if the battery is not maintenance-free. If necessary, recharge the battery (see Checking the
battery on page 60).
3. Reinstall the battery (see Replacing the battery on page 61).
4. Lubricate all the lubrication points (see Lubrication on page 47).
5. Run the engine for five minutes without turning on the mowing units to properly distribute the oil through the engine.
6. Make sure all the covers, screens and deflectors are fitted.
10.1 Safety checks
Check the safety system to see if the electronic safety lock circuit works correctly, see Testing the safety system on page
37.
1. Test the mowing switch.
2. Test the parking brake.
3. Test the seat mechanism.
4. Test the neutral position (if applicable).
5. Test the parking brake.
6. Test the raise/lower switch.
10.2 Tyre checks
1. Check the tyres for damage.
2. Check the tyre pressure with an accurate pressure gauge (see Technical specifications on page 33).
Recommissioning 70
To Next Page
Loading...
