Roberts Play M2 - Scan sensitivity setting - FM

14
Scan sensitivity setting - FM
Your radio will normally scan for FM broadcasts which are strong enough
to give good reception. However, you may wish the Auto-scan function
WRDOVREHDEOHWR¿QGZHDNHUVLJQDOVSRVVLEO\IURPPRUHGLVWDQWUDGLR
transmitters. Your radio includes a local / distant option for the Auto-scan
function.
1. Press the On/Off button to switch on your radio. Ensure your radio is
in FM mode.
2. Press the Menu/Mode button. The FM menu will show on the display.
3. Press the Tuning Up or Down buttons until 'SETTING' shows on the
display. Press the Select button to enter the scan settings menu.
4. Press the Tuning Up or Down buttons to switch between 'LOCAL'
and 'DISTANT'RSWLRQV7KH'LVWDQWRSWLRQZLOODOORZWKHUDGLRWR¿QG
weaker signals when scanning.
5. Press the Select EXWWRQWR FRQ¿UP \RXU VHOHFWLRQ7KH GLVSOD\ ZLOO
return to the radio display after several seconds.The Local or Distant
setting is stored in the radio and remains in force until changed or
until a System Reset.
Note: The initial setting (out of the box, or after a System Reset) causes
the radio to ignore weaker (or more distant) signals.
1
3,4
2
3,4
3,5