Presetting stations
You may store your preferred DAB and FM radio stations to the preset station
memories. There are 6 memory presets in your radio, 3 for DAB and 3 for
FM. Presets are remembered by your radio in the event of a power failure.
The procedure for setting presets and using them to tune stations is the same
for FM and DAB modes, and is described below.
Storing a preset
1. Press the On/Off button to switch on the radio.
2. Tune to the required station as previously described.
3. To store the station as a preset, give a long press on the the required
Preset button (1-3) until the display shows, for example, 'P2 SAVED'.
The station will be stored under the chosen preset button. Repeat this
procedure as needed for the remaining presets.
4. Stations which are already stored in the presets may be overwritten by
following the above procedure.
Note: The radio station presets are retained in memory when the radio is
switched off and disconnected from the mains supply.
Recalling a preset
1. Press the On/Off button to switch on the radio.
2. Give a long press on the Menu/Mode button to select either the FM or
DAB mode.
3. Momentarily press the required Preset button (1-3). Your radio will then
tune to the station stored in the selected preset memory.
4. If a preset station has been stored, then the display will show either the
station name (for DAB stations) or the frequency (for FM stations). The
display will show, for example, 'EMPTY' if no station has been stored to
that preset.
17
1
3
2
3
To Next Page
Loading...
