EasyManua.ls Logo

Roberts RD70 - FM Radio Operation; Basic FM Tuning

Roberts RD70
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
Station List
Scan
Manual Tune
Prune Invalid
DRC
System Settings
DAB 16.34
>
>
>
>
>
>
Off
Proceed to prune the
invalid stations?
Prune Invalid 16:34
Yes No
103.40MHz
FM 16.34
Heart FM - The
best variety of
hits
Prune stations - DAB
If you move to a different part of the country, some of the stations which were listed may
no longer be available. Also, from time to time, some DAB services may stop broadcasting,
or may change location or frequency. Stations which cannot be found, or which have
not been received for a very long time are shown in the station list with a question mark.
The Prune stations function will delete the marked DAB stations from your station list.
1. When in DAB mode, press Menu.
2. Choose 'Prune Invalid' and then choose 'Yes' to cause the invalid station names to
be removed from the station list.
3. If you do not wish to prune stations choose 'No' in step 2 above.
Note: If you have moved your radio to a different part of the country you should also carry
out a search for new stations (please see the section 'Finding new stations' on page 7).
Operating your radio - FM
1. Carefully extend the telescopic aerial fully. Press On/Off to switch on the radio.
2. Press Mode until the 'FM' mode is selected.
3. Rotate the Tuning control clockwise. The displayed frequency will increase. Press the
Tuning control to carry out an auto-tune. Your radio will scan in an upwards direction (low
IUHTXHQF\WRKLJKIUHTXHQF\DQGVWRSDXWRPDWLFDOO\ZKHQLW¿QGVDVWDWLRQRIVXI¿FLHQW
strength.
4. The display will show the frequency of the signal found. If RDS information is available,
after a few seconds the display will show the radio station name. If you only hear hiss
or interference, simply press the control to scan further.
5. To scan down in frequency, rotate the Tuning control anti-clockwise and then press the
control. Your radio will scan the FM band in a downwards direction (high frequency to
low frequency).
6. When the waveband end is reached your radio will recommence tuning from the opposite
waveband end. Adjust the Volume.
7. To switch off your radio press On/Off.

Related product manuals