8
Manual tuning - DAB
Manual tuning allows you to tune your radio to a particular DAB frequency in Band III.
Any new stations found will be added to the station list. This function can also be used
to assist the positioning of the telescopic aerial or the radio to optimise reception for a
VSHFL¿FFKDQQHORUIUHTXHQF\
1. Press Mode until the 'DAB' mode is selected.
2. Press Menu.
3. Choose 'Manual Tune' and then choose the desired DAB channel.
4. Press Tuning to tune to the chosen frequency.
When the radio has tuned, the display shows the channel number and frequency,
and the name of the DAB multiplex found. (if any). A bar graph shows the signal
strength and is useful if you need to reposition the radio or its aerial. The minimum
signal marker 'I' which separates the left and right parts of the signal graph shows
the minimum signal level required for satisfactory reception.
Any new radio stations found on the tuned DAB multiplex will be added to the list
stored in the radio.
5. Press Menu to exit.
Station List
Scan
Manual Tune
Prune Invalid
DRC
System Settings
DAB 16.34
>
>
>
>
>
>
Off
11B 218.640MHz
11C 220.352MHz
11D 222.064MHz
12A 223.936MHz
12B 225.648MHz
12C 227.360MHz
12D 229.072MHz
Manual Tune 16.34
>
>
>
>
>
>
>
Dynamic Range Control (DRC) settings - DAB
The DRC facillity can make quieter sounds easier to hear when your radio is used in a
noisy environment.
1. When in DAB mode, press Menu.
2. Choose 'DRC' and then choose the required DRC setting (default is Off).
DRC Off - DRC is switched off, Broadcast DRC will be ignored. DRC Low - DRC level
is set to 1/2 that sent by broadcaster. DRC High - DRC is set as sent by broadcaster.
3. Press Tuning WRFRQ¿UPWKHVHWWLQJ
Note: Not all DAB broadcasts use the DRC function. If the broadcast does not provide
DRC information, then the DRC setting in the radio will have no effect.
Station List
Scan
Manual Tune
Prune Invalid
DRC
System Settings
DAB 16.34
>
>
>
>
>
>
Off
High
Low
Off
DRC 16.34
Manual Tune 16.34
12B 225.648MHz
Strength:
To Next Page
Loading...
