Roberts RD70 - Headphone Socket; Auxiliary Input Socket

24
Auxiliary input socket
1. Connect a stereo or mono audio source (i.e. CD player, MP3 player,
etc.) to the Auxiliary input socket.
2. Press On/Off to switch on the radio.
3. Press Mode until the display shows 'Auxiliary Input'.
4. Adjust the Volume control on your player and on the radio for comfortable
listening.
5. Remove the cable from the Auxiliary input socket or press Mode
button to cancel Auxiliary Input mode.
Note that audio played via the auxiliary input will be played in mono
through the speaker and in stereo through stereo headphones.
Line Output socket
A 3.5mm Line Output Socket located underneath your radio is provided
IRUFRQQHFWLQJWKHDXGLRVLJQDOWRDQH[WHUQDODPSOL¿HU,QVHUWLQJDOLQHRXW
audio cable will not mute the internal loudspeaker. Set the volume control
on the radio to minimum is desired.
Sleep
Line
out
DC
7.5V /0.8A
Headphone socket
A 3.5mm Headphone Socket located in the top left hand corner of your radio
is provided for use with either headphones or an earpiece. Inserting a plug
automatically mutes the internal loudspeaker.
Please be aware that the sensitivity of headphones can vary widely. We therefore
recommend setting the volume to a low level before connecting headphones
to the radio. IMPORTANT: Excessive sound pressure from earphones and
headphones can cause hearing loss.
Sleep
To prevent possible hearing damage, do not listen at high volume
levels for long periods.
1