Roberts RD70 - Initial Setup and Operation; Connecting to Power and First Scan

5
8VLQJWKHUDGLRIRUWKH¿UVWWLPH
1. Plug the mains adaptor into the DC input socket located underneath
your radio (marked 'DC') ensuring that the plug is pushed fully into
the socket.
 3ODFH\RXUUDGLRRQDÀDWVXUIDFH
3. Carefully extend the telescopic aerial located on the top right
hand corner of your radio.
4. Plug the other end of the mains adaptor into a standard mains
socket outlet and switch on the wall socket. Whenever the adaptor
is used the batteries are automatically disconnected.
5. The display on the radio will show 'Revival by Roberts'. During
WKLVWLPHWKHUDGLRLVVFDQQLQJWR¿QGD'$%UDGLRVLJQDO$IWHUD
short time the current time will appear on the display.
6. If no signal is found, it may be necessary to relocate your radio
to a position giving better reception. You should then carry out a
VFDQWR¿QGQHZVWDWLRQVDVGHVFULEHGRQSDJH
7KH$&DGDSWRUVKRXOGEHGLVFRQQHFWHGIURPWKHPDLQVVXSSO\DQG
IURPWKHUDGLRZKHQQRWLQXVH
IMPORTANT: The mains adaptor is used as the means of connecting
the product to the mains supply. The mains socket and any multi-way
mains block used for the product must remain accessible during
normal use. In order to disconnect the product from the mains, the
mains adaptor should be removed from the mains socket completely.
Use only the mains adaptor provided with the product, or a genuine
replacement provided by Roberts Radio. The use of alternative adaptors
will invalidate the guarantee.
Line
out
DC
7.5V /0.8A