Robertshaw SENSE SMART 2000 - Adjusting Held Temperature; Reviewing Set Temperature; COMMERCIAL PROGRAMMABLE MODE; On;Off and Mode Selection

30
Ifdesired,whiletheprogramisheld,thecurrentsettemperaturecanbeadjusted
by pressing and holding the p or  buttons for three seconds. The thermostat
displaywillchangetoshowthewordSET,andtheacvesetpointforthecurrent
mode(HeangorCooling).Asyouholdthep or buttons, the current setpoint
will change.
To Review the Set Temperature
Press the p or  buttonstorstturntheLCDbacklightON,thenpressagainto
display the currently set temperature(s).
COMMERCIAL PROGRAMMABLE MODE
On /Off and Mode Selection
PresstheModebuontocyclethethermostatthroughtheavailablemodes,
Heat,Cool,Automode(ShownbyHEATandCOOLintheLCD),EmergencyHeat(if
ed),andOFF.IftheFanmodeissettoFANON,whenyouselectOFFmodethe
FanmodewillautomacallychangetoFANAUTO.
NOTE: Not all modes may be active on your thermostat.
Setting the Fan Functions
DetailonthefancontrolfunconsoftheSMART2000canbefoundonpage15
of this manual.