11.
CHECKS
and
CORRECTIONS
After disassembling and cleaning the engine, check and repair, if necessary, according to the correction table. The correction
table applies whenever the engines are repaired. It is important for the servicemen to be familiar with the contents of
tlus
table. Correct maintenance
is
recommended by observing the correction standards specified.
The meanings
of
the terms used in the correction table are
as
follows:
1) Correction
Repair, adjustment or replacement of any engine parts.
2)
Correction Limit
The limit on wear, damage or functional deterioration of engine parts beyond which normal engine performance can-
not be expected without repairing such parts.
3)
Use Limit
The limit beyond which parts can no longer be used in respect of performance.or strength.
4)
Standard Dimensions
The design dimensions of new parts minus tolerance.
5)
Correction Tolerance
Tolerance on the dimensions of engine parts refinished or adjusted.
-
37
-
To Next Page
Loading...
Need help?
General
