6.
SAFETY PRECAUTIONS
1.
2.
3.
4.
5.
6.
7.
Use extreme caution near fuel. A constant danger of explosion or fire exists.
Do
not fill the fuel tank while the engine is running.
Do
not smoke
or
use opern flame near the fuel
tank. Be careful not to spill fuel when refueling.
If
spilt, wipe it and let dry before starting the engine.
Do
not place inflammable materials near the generator.
Be careful not to put fuel, matches, gunpowder, oily cloth, straw, and any other inflammables near the
generator.
Do
not operate the generator in
a
room,cave or tunnel. Always operate in a well-ventilated area.
Otherwise the engine may overheat and also, the poisonous carbon monoxide contained
in
the exhaust
gases will endanger human lives. Keep the generator at least
1
m
(4
feet) away from structures or
facilities during use.
Operate the generator on
a
level surface.
If
the generator is tilted or moved during use, there is a danger of fuel spillage and a chance that the
generator may tip over.
Do
not operate with wet hands or in the rain.
Severe electric shock may occur.
If
the generator is wet by rain or
snow,
wipe it and thoroughly dry
it
before starting.
Don't pour water over the generator directly nor wash
it
with water.
If
the generator
is
wet with water, the insulations will be adversely affected and may cause current
leakage and electric shock.
Do not connect the generator to-the commercial power lines.
This
may cause a short-circuit or damage to the generator.Use a transfer switch for connecting with
indoor wiring.
NOTE: The parts numbers of the transfer switches and of the plastic box to store them are as
shown in Table
6-1.
!
Part No.
j
Part Name
'
Q'ty
'
Phase
Allowable Current
!
365-45604-08
1j1j
60A
340-45606-08
j
Transfer Switch
30A
1
I
367-45605-08
,
Transfer Switch
I
1
15A
1
1
Transfer Switch
!
367-43008-08
I
Plastic
Box
30A
1
1
i
348-43009-08
j
Plastic
Box
I
1'1
i
60A
Table
6-
7
Be
sure to check and remedy
the
cause
of
circuit breaker tripping before re-setting
it
on.
CAUTION
:If the circuit breaker tripped
off
as a result of using an electrical appliance,the cause
can be an overload
or
a short-circuit. In such a case, stop operation immediately and carefully
check the electrical appliance and
AC
plugs for faulty wiring.
-
28
-
To Next Page
Loading...
Need help?
General
