Roche Accu-Chek Active - If the Transfer Is Unsuccessful

37
6
Analysing test results on the PC
To turn the meter o, unplug the
USB connector from the meter
once the data transfer is
complete.
For approximately 3 seconds,
is displayed.
The meter turns itself o.
i
The meter is supplied with
electricity via the USB cable
while it is connected to the
computer. Nonetheless, there
must be a battery in the meter.
If the transfer is unsuccessful
If the test results are not transferred ( is still flashing on the display), the meter turns itself o
automatically after approx. 90 seconds. There can be dierent reasons for a failed transfer. Eliminate the
cause and start the transfer again.
Check
• if both USB connectors are properly inserted.
• if the USB cable is damaged (e.g. kinks in the cable).
• if all device drivers necessary for communication between the diabetes management software and the
meter are installed.
• if your diabetes management software is compatible with the Continua standard. You can tell by this
logo:
54
man_06658768001_02_EN.indb 37 14.08.2013 10:19:38