34
GIANNINO
4 - INSTALLATION
The installation must be performed by
qualied technical personnel. The instal-
lation must be performed in conformity
with current safety regulations of the
Country where the product is used.
The machine must only be installed in places where it
is easy to use and access.
The support surface must be at, dry, smooth and guar-
antee perfect stability.
The recommended height of the base is at least approx-
imately 90-100 cm from the ground (g._4.1)
Do not use or install where water jets are used.
g_4.1
In order to ensure normal operation, the machine must
be installed in areas where the room temperature
is between +5°C and +36°C and humidity does not
exceed 70%.
Ensure that there is an open area of at least 10 cmon
each side and at least 30cm above the machine to
allow adequate ventilation, simple coee relling and
facilitate its use and the performance of any mainte-
nance operations (g._4.2)
If the machine is wet or very damp,
wait until it is completely dry before
installing or using it.
g_4.2
MACCHINA
IN
MANUTENZIONE
VIETATO
L’ACCESSO
oltre questo limite
ATTENZIONE
ORGANI
IN MOVIMENTO
ATTENZIONE
CORRENTE
ELETTRICA
MANUTENZIONE ORDINARIA
OLIARE INGRASSARE
TUTTE LE PARTI IN MOVIMENTO
OGNI 30 GG
EN
To Next Page
Loading...
