Rocket GIANNINO - Dose Time Adjustment; Fork Adjustment

39
GIANNINO
5.3 Dose time adjustment
With the machine switched on, press the central “R”
symbol (1 - g._5.6)until the dose time is shown on the
upper part of the display (g._5.6) to change the time
of the programmed doses.
To change the time of the programmed doses, select
the desired dose between single, double or triple (the
single dose is selected as default - e.g. 2 - g._5.6).
Once the desired dose is selected, the corresponding
LED will start ashing and you will be able to adjust
the timer.
Press the “+” or “-“ (3 - g._5.6) if you wish to increase
or decrease the dose time.
Press the “R” symbol at the centre of the display for
a couple of seconds to exit the programming menu.
1
2
3
g_5.6
5.4 Fork adjustment
All models are supplied with a fork height adjustment
device. To change the height, loosen the screws by
half a turn (4 - g._5.7) and move the fork (5) to the
desired position. The correct height of the fork (g._5.8)
is obtained when the prole of the lter holder ts
perfectly in the groove of the support pin. (6 - g._5.7)
Fasten the screws to guarantee a secure support to
the lter holder.
g_5.7
g_5.8
EN
?