22
Joining the sender/receiver to the wireless speaker
The sender/receiver and the wireless speaker must be “joined” or
wirelessly connected to each other, so that audio can be sent from
the sender/receiver to the speaker.
Note: Use this procedure only if you need to rejoin the sender/receiver and wireless
speaker and this is your only Rocketboost-enabled product.
To join the sender/receiver to the wireless speaker:
1 Set the HUB switch on the sender/receiver to ENABLE if this is your first
Rocketboost™ product set.
• The power indicators turn green when the HUB switch is set to ENABLE.
• The power indicators turn blue when the HUB switch is set to DISABLE.
2 Press and hold the button on the sender/receiver for more than three
seconds to put it into joining mode. The power indicator starts blinking
rapidly and the unit will stay in joining mode for 30 seconds.
Wireless speaker
Sender/receiver
(HUB: ENABLE)
Other
Rocketfish
devices
TM
Power on
indicator
10-1209 RF-RBWSO2_MAN_V3.fm Page 22 Monday, October 25, 2010 2:23 PM
To Next Page
Loading...
