RocketFish RF-RBWS02 User Manual

23RF-RBWS02
3 Press and hold the button on the wireless speaker for more than three
seconds so the sender/receiver and wireless speaker enter joining mode.
• The power indicators light steadily if the joining was successful.
• The power indicators blink slowly if the joining was not successful.
Note: Rocketboost devices have their own memory. After the devices are joined once,
they will remember each other and join automatically when your devices are
powered on again. Because of this, you can join all of your network components in
the same room before installing them in their permanent locations throughout the
house.
Joining the sender/receiver and wireless speaker to an
existing Rocketboost network
Use this procedure only if you are adding this product to an existing
Rocketboost network.
You need to join both the sender/receiver and the wireless speaker to
your existing hub device, using the following steps.
CHARGE
BASS
POWER/JOIN
CHANNEL
L - MONO - R
SOURCE
TM
Power on
indicator
10-1209 RF-RBWSO2_MAN_V3.fm Page 23 Monday, October 25, 2010 2:23 PM

RocketFish RF-RBWS02 Specifications

General

Brand	RocketFish
Model	RF-RBWS02
Category	Speakers
Language	English