45Publication 2711C-QS001F-EN-P - November 2010 45
Chapter
5
Create Tags
Introduction
In this chapter, you will create tags used by the sample application. You must create tags before you can
assign them to objects.
Before You Begin
• Review the sample application.
• Connect your terminal to your computer and launch the PanelView Explorer software.
• Configure browser settings.
• Open a new application.
• Configure runtime communication settings for the application.
What You Need
• Runtime communication settings defined. Tags require the controller name defined on the
Communication tab. In this application, the controller settings use the default name PLC-1.
Topic Page
Review Application Tags 46
Open the Tags View 47
Create External Tags 47
To Next Page
Loading...
