1769-L32E, 1769-L35E CompactLogix Controller 27
Publication
1769-IN020D-EN-P - October 2008
9. To start the update of the controller, click Finish and then click Yes.
After the controller is updated, the status dialog displays Update
complete.
10. Click OK.
11. To close the ControlFlash utility, click Cancel and then click Yes.
Use AutoFlash to Load Firmware
You can use AutoFlash to load firmware through a network connection.
1. Make sure the appropriate network connection is made and your
network driver is configured in RSLinx software.
2. Use RSLogix 5000 programming software to create a controller
project.
3. Click RSWho to specify the controller path.
4. Select your controller and click Download.
You may also choose to click Update Firmware to complete this
process. If you do so, skip to step 8
.
A dialog box displays indicating that the project revision and
controller firmware revision are different.
IMPORTANT
When upgrading your controller firmware, it is extremely important to allow
the upgrade to complete without interruption.
If you interrupt the firmware upgrade either in the software or by distrubing
the physical media, you may render the controller inoperable.
For more information about upgrading your CompactLogix controller
firware, see information posted at
http://www.rockwellautomation.com/knowledgebase/
.
To Next Page
Loading...
Need help?
General
